The DKM TP series of two-platen injection molding machins is an injection molding machine designed for the ultra-large size plastic parts with
a clamping force starting from 6000kN up to 40,000kN, which is widely applicable to large plastic products, automotive part, and high-gloss plastic
products. With a payload up to 75kg, the SWITEK SW7 series 3 axis servo robotic arm is one of the best choice for the picking of the parts from the DKM TP sreies of
two-platen injection molding machine in the projects named above.
The Features of DKM TP Series Two-platen Injection Molding Machine
HIGH STABILITY
Enhanced strength and rigidity of mechanical parts, with the help of finite element analysis
H type clamping plate for high precision
Double sliding structure for moving and fixed plate to make the parallelism even for large size mould
Moving plate guide by machine bottom and slide to eliminate any titling torque and increase mould bearing capacity
HIGH RELIABILITY
Tie bars are fixed to the stationary plate for convenient installation for large size mold
Tie bar nut and clamping piston are suspension structure to fully protect tie bar in band-type brake unit, this greatly increase
machine life with high reliability and good performance
HIGH FLEXIBILITY
Inversion type ejection system, the ejection stroke could be set up as per particular production requirement
HIGH PRECISION
Fully closed hydraulic system for less leakage was adopted for less leakage and better pressure holding
Operation with locknut for rapid and accurate reaction
Four hydraulic cylinders installed on moving platen to create clamping force fast with balanced pressure
Pressure sensor used to monitor the clamping force
HIGH MOULD THICKNESS CAPACITY
More than 50% opening stroke, mould thickness capacity etc.
The operation, installation and production full of humanization
HIGH ENERGY SAVING
World famous brand servo system for low energy consumption
Machine size is 30% smaller than three plate machine
HIGH SAFETY
European brand servo system for low energy consumption
European CE standard for safe operation
Why is SWITEK SW7 Series Servo Robot One of the Best Robot for DKM TP Series of Injection Molding Machine?
The SWITEK SW7 series of servo robot a heavy duty robotic arm with a starting payload from 15kg and up to 75kg and is suitable for injection molding machine
form 500T~4000T, the features of the SW7 series servo robot include:
Kick-back design, providing 30% more EOAT moving space, which is the best solution for deep cavities or large size containers picking.
With payload up to 75kg, promise a stable picking of the large size or deep cavity containers.
Easy installation with a A/C servo posture for parts picking from a complex structure designed mold.
Rich I/O reservation for easy integrating in an automation system.
With stardard spareparts supplied by globally renowned brand, reduce your maintenance cost.
Tips of Robot Selecting for Your Injection Molding Machine
The height of the robotic arm + the height of the injection molding machine < the height of the crane L;
The vertical stroke of the robotic arm (Y) will reach the mold center;
The EOAT will reach a height over the safe door (D-N);
The crosswise stroke (X2) is sufficient to pick the parts from the movable platen of the injection molding machine;
The traverse stroke (Z) is long enough to place the parts on the conveyor (B+C for operator side parts dropping or A+C for non-operator
side parts dropping);
The robot has sufficient payload to load the right EOAT for parts picking;
To install an A/B/C servo posture for the parts picking from a complex structure mold;
The robot has a correct interface (EU12/EU67/JIS) to communicate with the injection molding machine;
The robot has sufficient I/O reservation for complex EOAT or automation integration;