The ONGO N388 is a high speed injection molding machine designed for the fast injection molding of thin-wall containers. With a clamping
force up to 3880kN and an opening stroke of 660mmm, the ONGO N388 is suitable for the injection molding production of 700ml beverages up to 8 cavities. With a dry cycle time of 3.3s and
an in mold time lowered to 0.7s, SWITEK SW7112DS is one of the best picking robot for such a project.
The Features of ONGO N388 High Speed Injection Molding Machine
Injection Cylinder Double Rod
Special injection piston rod design, the force balancce, can prolong the use time of oil seal. Significantly reduce the amount of oil
back to the high speed of injection, so as to reduce the oil resistance of injection.
Injection Speed: Paralle movement and high-speed/low pressure injection movement that shortens circle time. especially for thin wall products.
Low Friction Design: The injection unit used linear guide, bo minimize the friction and increase speed during injection.
Newly Designed Enhanced Template
Improved platen with high rigidity structure, especially suitable to thin-wall products.
Tie Bar: The tension rod is made of alloy steel and strengthening design, to extend the service life of high speed running condition.
Screw & Barrel
Can be optional infrared thermal insulation device, has the advantages of fast heating, energy saving, long life and other advantages, to
further enhance the plasticization quality.
Why is SWITEK SW7112DS One of the Best Fast Picking Robot for ONGO N388 High Speed Injection Molding Machine?
As a high speed 3 axis servo robotic arm designed for the fast picking of thin-wall containers from the injectin molding machine, the advantages
below make it one of the best picking robot for the ONGO N388 high speed injection molding machine:
Dry cycle time lowered to 3.3s.
With in mold time lowered to 0.7s.
Suitable for injection molding machine with clamping force from 2000kN to 5000kN.
User friendly interface, easy operating with lower training cost.
With the main components made by big names, lower maintenance cost.
Optional EU12/EU67/JIS interface, easy connection to the injection molding machine.
Parameters of SWITEK SW7112DS High Speed Picking Robot
Tips of Robot Selecting for Your Injection Molding Machine
The height of the robotic arm + the height of the injection molding machine < the height of the crane L;
The vertical stroke of the robotic arm (Y) will reach the mold center;
The EOAT will reach a height over the safe door (D-N);
The crosswise stroke (X2) is sufficient to pick the parts from the movable platen of the injection molding machine;
The traverse stroke (Z) is long enough to place the parts on the conveyor (B+C for operator side parts dropping or A+C for non-operator
side parts dropping);
The robot has sufficient payload to load the right EOAT for parts picking;
To install an A/B/C servo posture for the parts picking from a complex structure mold;
The robot has a correct interface (EU12/EU67/JIS) to communicate with the injection molding machine;
The robot has sufficient I/O reservation for complex EOAT or automation integration;